Strip Seal Expansion Joints

DESCRIPTION

Monolithic Single Strip Seal Expansion Joint (Strip Seal Expansion Joints) for movements of up to 80 mm are expansion joints made of a single set of structural steel, rubber sealing strips and headed studs. In order to meet the requirements of the bridge deformation, strip seal expansion joints are usually set at each end of the bridge, between ends of the beam and abutment or on the hinge joints of the bridge. They are applied with rubber noise weaken board which can help to increase movement and reduce noise from over-passing traffic by up to 80%.

Compression Seal Expansion Joint consists of steel armoured nosing at two edges of the expansion joint gap suitably anchored to the deck concrete and a performed chloroprene elastomer compressed and fixed into the joint gap with special adhesive girder. It is recommended for simply supported or continuous spans right or skew moderately curved with maximum horizontal movement not exceeding 40mm. In order to meet excellent quality standards, we are supplying Compression Seal Expansion Joint.